Network Tip No. 9: show Commands

show Commands Router#show ? Lists all show commands available Router#show interfaces Displays statistics for all interfaces Router#show interface serial 0 Displays statistics for a specific interface, in this case Serial 0 Router#show ip interface brief Displays a summary of all interfaces, including status and IP address assigned Router#show controllers serial 0 Displays statistics for interface hardware. Statistics display if the clock rate is set and if the cable is DCE, DTE, or not attached Router#show clock Displays time set on device Router#show hosts Displays local host-to-IP address cache. These are the names and addresses of hosts on the network to which you can connect Router#show users Displays all users connected to device Router#show history Displays history of commands used at this edit level Router#show flash Displays info about Flash memory Router#show version Displays info about loaded software version Router#show arp Displays the ARP table Router#show protocols Displays status of configured Layer 3 protocols Router#show startup-config Displays configuration saved in NVRAM Router#show running-config Displays configuration currently running in RAM